RAIN BIRD ESP MODULAR ANLEITUNG Pdf-Herunterladen (2024)

FAQs

How to install Rainbird module? ›

Reset the WiFi module. While plugged in, press and hold the button on the WiFi module for 5 seconds. The LED should turn Amber colored, and then red, followed by three green blinks, followed by red and green alternating (WiFi Hotspot).

This is often caused by water or other debris getting into the motor and causing it to overheat. To determine whether your motor is burnt out, try turning on your pump and checking for any unusual smells or sounds.

The ESP-Me can control a pump start relay, to turn the pump on and off as needed. A Connect a wire from the pump start relay (PSR) to the. master valve terminal (MV) on the base module. Then connect another wire from the pump start relay to the field common wire, as shown.

The light blinks GREEN and RED to indicate hotspot mode. network in the phone/tablet's WiFi settings menu. Program your irrigation controller from anywhere, anytime! Scan this QR code or visit wifi-pro.rainbird.com/support to watch setup and support videos.

The controller password is restricted to letters and numbers, 4-8 digits in length. No special characters. If you use a special character it will not be registered in the password. As an example, if you typed in 1234@, the password would be stored as 1234.

This is most likely due to the controller being on the far range of the WiFi signal broadcasted by your home's WiFi router. The best way to check this is to open the Rain Bird mobile app when it is connected and select the controller from the list of available controllers.

If needed, boost signal by adding a wireless router or moving controller and router closer together. Issue: Controller is not connected to mobile device and STATUS on controller interface is blinking blue. Solution: The controller needs to be connected to your mobile device for the first time.

Is the water turned on, is the controller plugged in and programmed correctly, are there isolation valves that might be turned off? Verify valve operation by using the manual bleed. This might indicate a controller or wiring problem if the valve works properly when using the manual bleed.

How do I use Rain Bird emitter installation tool? ›

Using the Emitter Tool

Place the Spot Watering Emitter on end of tool. Press barbed point into side wall of ½" Tubing. Note: The Emitter Tool also works with ¼" Barbed Couplings and with ¼" Barbed Tees. Pull tool away, leaving the Spot Watering Emitter embedded in tubing.